I've been reading up on the Hovrs FAQs and on the forums for the new MVP port forward settings and so far I've found is:
Hovrs FAQs:
Port Function Outbound Connection
389 Internet Locator Service (ILS) TCP
522 User Location Service TCP
1503 T.120 TCP
1720 H.323 TCP
1731 Audio call control TCP
Dynamic H.323 call control TCP
Dynamic H.323 streaming Real-Time Transfer Protocol (RTP) over UDP
Also, from another post from another thread I found out these settings but there's 3 versions, so, I'm not sure how to distinguish what:
I have two different sets of numbers, I just want to accomplish 2 things which is use the MVP and the VP-200 alongside each other as well as receive calls on both the MVP and VP-200. Any suggestions on how I start to go about this? I'm fluent in basic home networking and know my way around my router. Thanks in advance.
Hovrs FAQs:
Port Function Outbound Connection
389 Internet Locator Service (ILS) TCP
522 User Location Service TCP
1503 T.120 TCP
1720 H.323 TCP
1731 Audio call control TCP
Dynamic H.323 call control TCP
Dynamic H.323 streaming Real-Time Transfer Protocol (RTP) over UDP
Also, from another post from another thread I found out these settings but there's 3 versions, so, I'm not sure how to distinguish what:
Port Rules for VideoPhone and MVP hardware
Applications Rules
Validate the ports are configured as detailed below:
OJO Ports: 5010-5017 UDP
SIP Ports: 5060-5061 TCP/UDP
Sorenson/Dlink Ports: 15328-15348 TCP/UDP
General H.323 Ports: 1720-1721 TCP/UDP
MVP RAS and H.245 Ports: 7950-7999 TCP
MVP Audio Ports: 8000-8032 TCP
i711 Ports: 9980 TCP
VPAD/VPAD+ Ports: 4100
Port Forwarding
MVP
1720-1721 into the TCP and UDP boxes
192.168.0.25 into the IP Address box
MVP1
7950-7999 into the TCP and UDP boxes
192.168.0.25 into the IP Address box
MVP2
8000-8032 into the TCP and UDP boxes
192.168.0.25 into the IP Address box
Video Phone Ports
The information is intended only for use when configuring other routers for use with MVP solutions.
MVP
The port numbers used by the MVP-500 are:
1719 (TCP)
1720 (TCP)
7950 – 7999 (TCP)
5060 (UDP)
8000-8032 (UDP)
DLINK DVC-1000
The port numbers used by the DVC-1000 are:
1720 (TCP)
15328 (UDP & TCP)
15329-15333 (TCP)
Sorensen VP-100 / VP-200
Inbound Ports:
1720 (UDP & TCP)
15328 (UDP & TCP)
15329-15348 (TCP)
Outbound Ports:
1024 – 65535 (UDP & TCP)
21 (FTP)
80 (HTTP)
OJO
5010-5017 (UDP)
5060 (UDP)
VPAD/VPAD+
41000 (TCP)
42000-42014 (UDP & TCP)
If you own non-wireless router, we can switch Purple DIR-615 wireless router with GoAmerica firmware while getting new MVP
I have two different sets of numbers, I just want to accomplish 2 things which is use the MVP and the VP-200 alongside each other as well as receive calls on both the MVP and VP-200. Any suggestions on how I start to go about this? I'm fluent in basic home networking and know my way around my router. Thanks in advance.