Linksys Wrt300n Setting And Vp200
LInksys WRT300N Firmware verison 1.03.3
when you login into Linksys set up page
open the browser you have to enter the URL address : 192.168.1.1 to pop up the login
when you got pop up the login : you have to enter the password: admin but user id or user name (leave blank)
after login successful,
you will see basic set up page you do not have to change it and you have to click to "Applications & Gaming" tab and you see "Single Port Forwarding" page do not need to change "Single Port Forwarding" you have to click to "DMZ"
you see "DMZ" page: when you see DMZ is Disabled, you have to change to "Enabled"
you do not have to change "Source IP Address" and selected " Any IP Address"
if you see "Destination" -- IP Address 192.168.1. you have to put 125
click Save Settings then Close Browser
If you use WiFi on your desktop or laptop,
click Start ---> Connect to ----> Wireless Network Connection ----> click "Support" tab -----> Click "Details" you do not close it
until you have to complete for your VP settings
or Start ----> Show All Connections----> (right click) "Wireless Network Connection"----> click 'status" ---> "Support" tab---->"Details"
Or If you are connected via Ethanet for your laptop or desktop
click Start --->Show All Connections----> (right click) Local Area Connection ----> click "status"----> click "Support" tab ---"Details"
you have to go VP200 videophone: that your VP connected to thorugh an ethanet to Linksys WRT300N router
you have to click "Settings" then "Network" then "Address"
you have to click Edit when you see pop up "Caution" window if you know the access code you have to enter your access code when you got success for access code to thorugh IP Address Settings
If you do not have an access code you have to call Soresnon VRS Techincal Support at (801) 287-9403 VP to obtain for your access code.
you have to remove " Obtain an IP address automatically (DHCP)
you have to modify the settings are:
IP Address: 192.168.1.125
Subnet Mask 255.255.255.0
Gateway 192.168.1.1
Host Name VP200
you have copy from Network Connection Details windows to your VP200:
you will see DNS if you have 2 DNS Servers from your own ISP you have to put in your VP200 setting for manual DNS Server from your ISP for Primary & Secondary DNS
when you finish put both of DNS Servers then click OK then restart VP200 and VP200 reboot few minutes when you got appears for your VP number mean you are success.
To test call to Tech Support VP 801-287-9403 when you connect Tech Support to make sure it works for sending and receive without blocking
if you have only one DNS Server If you don't have Secondary DNS Server you just leave blank on "Secondary DNS" you just put Primary DNS when you have only one DNS server. then click OK restart VP200 when after reboot until you got your VP phone number appears mean it's works
when you are done setting you can close all of the Network Connection windows and .you enjoy the VP chat or call VRS anytime