How do I call an I.P. number on VP 200?

[Bright-Eyed-TJ]

Hi thank you for reading!

So I'd like to make a VP phone call tomorrow. This person has a VP that only uses IP numbers.

I don't see an option on the Sorenson VP-200 to call someone with IP number only.

I feel lame, :Oops: but how do I do this? It's possible, yes?

Appreciate any help!

Thank you in advance, also.

 

[rhr]

you can both xxx xxx xxxx for phone number or xxx.xxx.xxx.xxx for must 3 dot will run IP address, phone number or IP address in one command line

 

[diehardbiker]

Yup, on vp-200 remote you will see DOT button, right above the mine button. Do not use asterik (*)

you can both xxx xxx xxxx for phone number or xxx.xxx.xxx.xxx for must 3 dot will run IP address, phone number or IP address in one command line

 

[Bright-Eyed-TJ]

Thank you! I was not given that many numbers, it looks like this: 66.176.54.14

Could I type it in just like this above? Thank you very much!

 

[Brian]

Thank you! I was not given that many numbers, it looks like this: 66.176.54.14

Could I type it in just like this above? Thank you very much!

Yes, you can use that - it will work.

 

[Bright-Eyed-TJ]

Appreciate your help so much everyone! THANK YOU!